Your pre-built complete will come ready to ride, but a few minor adjustments can improve its performance and make it easier to learn.

There’s no universal setting—factors like the rider’s size, weight, skating style, and personal preference all play a role.

TOOLS NEEDED

An all-in-one skate tool is recommended as it has everything you will need.

ADJUSTING TRUCKS

Turn the 9/16" kingpin nut clockwise to tighten or counter clockwise to loosen.

Begin by standing on your board and shifting your weight from your heels to your toes.

The deck should tilt from side to side with minimal effort. If it feels stiff, the trucks may be too tight—loosen the kingpin nuts.

If the board tilts so much that the deck easily touches the wheels (known as wheelbite), the trucks may be too loose—tighten the kingpin nuts.

Tighter trucks provide more stability, while looser trucks allow for easier turning.

Truck tightness is all about personal preference, so make small adjustments until you find what is most comfortable for you.

ADJUSTING WHEELS

Turn the 1/2" axle nut clockwise to tighten or counter clockwise to loosen.

Flip the board over and spin each wheel one at a time. If the wheel doesn't spin freely the axle nut may be too tight. If it’s too loose, the wheel may wobble or even come off.

Skateboard wheels should be tight enough to prevent excessive side-to-side movement while still allowing them to spin freely.

Tighten the axle nut until the wheel is snug, but not too tight, as that can damage the bearing. Then, back it off slightly until the wheel spins freely with a just small amount of play.

To extend the life of your wheels, rotate them when they start to show uneven wear.

BEARING CARE

This is a test.

MOUNTING HARDWARE

Turn the 3/8" hardware nut clockwise to tighten or counter clockwise to loosen while using a phillips screwdriver or 1/8" allen key to prevent bolt from spinning.

Mounting hardware should be tightened until snug, but not over-tightened. Over-tightening can damage the deck and hardware. The goal is to have the bolt heads flush with the grip tape, but not countersunk into the deck.

Regularly check and tighten hardware, as vibrations from riding can cause loosening.

SQUEEKY TRUCKS

New trucks may squeak initially, most will improve after being broke in.

Squeaky skateboard trucks are usually caused by friction between the trucks' components, primarily the pivot cup and bushings. Lubricating these areas can effectively eliminate the squeaking sound.